Low-Conductivity Coolant for Hydrogen Fuel Cell Thermal Management Systems

Application Scenarios:

• Hydrogen Fuel Cell Vehicles (Passenger Cars, Commercial Vehicles, Buses)

• Hydrogen Fuel Cell Power Generation Systems

• Hydrogen Energy Storage and Conversion Equipment

• Fuel Cell Test Benches and R&D Systems

• Industrial Hydrogen Fuel Cell Applications

How to Use:

1. Prior to filling, make sure the cooling system is clean. Remove any remaining fluids, pollutants, or debris from prior coolant systems.

2. This product can be used directly or diluted, depending on the system design needs. If dilution is required, use only highly purified or deionized water.

3. To avoid introducing air, slowly fill the coolant into the hydrogen fuel cell cooling system.

4. Bleed the system completely to eliminate any trapped air and maintain proper circulation.

5. After filling, run the system and check the temperature, flow rate, and electrical conductivity to ensure proper operation.

6. Check the coolant level and system condition on a regular basis while in operation.

Important Notes:

• Do not mix with regular automotive coolants or other fuel cell coolants, as this may impair electrical conductivity and corrosion prevention effectiveness.

• Avoid contact with incompatible fluids, oils, or contaminants that may increase conductivity.

• Keep in a sealed container to avoid moisture absorption and contamination.

• If the coolant becomes visibly polluted or the conductivity exceeds system restrictions, replace it immediately.

• Use adequate personal protection equipment (gloves, safety glasses) when handling.

• In the event of inadvertent contact with the eyes or skin, thoroughly rinse with clean water.

• Dispose of used coolant in compliance with local environmental rules.